Keyword search (3,619 papers available)


Finite Element Modelling of a Reflection Differential Split-D Eddy Current Probe Scanning Surface Notches.

Author(s): Mohseni E, França DR, Viens M, Xie WF, Xu B

J Nondestr Eval. 2020;39(2):29 Authors: Mohseni E, França DR, Viens M, Xie WF, Xu B

Article GUID: 32214578
Adaptive Neuro-fuzzy Inference System Trained for Sizing Semi-elliptical Notches Scanned by Eddy Currents.

Author(s): Mohseni E, Viens M, Xie WF

J Nondestr Eval. 2020;39(1):5 Authors: Mohseni E, Viens M, Xie WF

Article GUID: 31929668
Title:Adaptive Neuro-fuzzy Inference System Trained for Sizing Semi-elliptical Notches Scanned by Eddy Currents.
Authors:Mohseni E,  Viens M,  Xie WF
Link:https://www.ncbi.nlm.nih.gov/pubmed/31929668?dopt=Abstract
DOI:10.1007/s10921-019-0648-8
Category:J Nondestr Eval
PMID:31929668
Dept Affiliation: ENCS
1 1Department of Electronics and Electrical Engineering, Center for Ultrasonic Engineering (CUE), Technology and Innovation Centre, University of Strathclyde, 99 George Street, Glasgow, G1 1RD UK.
2 Département de génie mécanique, L'École de technologie supérieure, 1100 Rue Notre-Dame O, Montréal, QC H3C 1 K3 Canada.
3 3Department of Mechanical & Industrial Engineering, Concordia University, 1455 De Maisonneuve Blvd. W., Montréal, QC H3G 1M8 Canada.

Description:

Adaptive Neuro-fuzzy Inference System Trained for Sizing Semi-elliptical Notches Scanned by Eddy Currents.

J Nondestr Eval. 2020;39(1):5

Authors: Mohseni E, Viens M, Xie WF

Abstract

The present study explores the capability of COMSOL Multiphysics, as a finite element modelling (FEM) tool, to model the interaction between a split-D differential surface eddy current (ECT) probe and semi-elliptical surface electrical discharge machined (EDM) notches. The effect of the small probe's lift-off and tilt on its signal is investigated through modelling and subsequently, the simulation outcomes are validated using the probe's impedance measurements. In the next stage, an adaptive neuro-fuzzy inference system (ANFIS) is designed to take the signal features as inputs and consequently, provide the length of the scanned notch as the system's output. The system is trained by extracted features of thirty model-generated signals obtained from scanning of the same number of semi-elliptical notches by means of the split-D probe. The trained ANFIS is tested afterwards using the measured signals of 3 calibration EDM notches together with 5 model-based ones. A very low average estimation error is observed with regard to the length estimation of the test notches and the accuracy of the length estimation is found to be quite reasonable.

PMID: 31929668 [PubMed]